I came across a blog I wrote in 2010 about a repair on an old Hofner pickup, thought you might be interested:
I had a visit from Paul Crowther the other day (always a pleasure to see him). He’s rather a legend for amongst other things his ‘Hotcake’ overdrive pedals and the ‘Prunes and Custard’ (my favorite for theremin).
He wanted to know if my coil winding machine was up and running – he had an interesting pickup for me to wind.
Its an old Hofner pickup which I guess is from the 50’s. The guitar has 3 of them and this one has a break in the windings so needs to be re-wound.
This would normally be a straight forward job except for the design of this pickup.
This is the inside of it. The windings (around the outside) are not wrapped around a bobbin. They are just sitting in the pickup and have been wrapped in tape to protect them. In the middle you can see the magnets sitting in a hard putty. There are incidentally only 5 magnets.
So the problem Paul left me with was how to wrap about 5000 turns of extremely thin wire into a coil and therefore make a pickup.
After a long brainstorming session with Sheena we came up with a plan.
Very tricky re-wind
We figured that the wire had to be wound around a bobbin and then somehow the bobbin removed.
So I made this bobbin. The sides are plastic from a Strat pickguard (white) and the centre has been carved from candle wax.
The bobbin bolts together and is attached to another plastic plate which in turn fits to the winding machine.
The idea is to wind the pickup on this and then warm the completed coil up and melt the wax. The wax should seep into the coil thus potting it as well. Then the sides can be unbolted and voila a copy of the original coil.
Winding the coil wasn’t any different from any other pickup – so now for the tricky bit.
When I see some wax oozing out I ever so gently remove the top plate.
With the wax exposed I can apply more heat and watch it flow into the coil and as it cools becomes solid.
Then I wrap tape around it to hold everything in place. I cannot emphasize enough how fiddly this is. There are a few stray wires and if any of them break I’m starting again.
It may not be much to look at but its taken hours. The slight curve is to match the shape of the pickup casing. I’ve tested it and I’m pleased with it at 5.5Kohms.
In the background you can see the magnetic lugs – I had to dig them out of the putty.
I put the whole thing back together using ‘friendly plastic’ instead of putty then fill the casing with wax, solder the back on and its finished.
Its been quite a task but I’m happy with the result.
Hofner Pickup – an interesting repair
Enjoy this? You may also like…
updated July 2023